INSTALLATION OF THE MEDIAMASTER
Connecting an analogue satellite receiver and a VCR
•Connect a SCART cable between the main SCART socket on the TV and the TV SCART socket on the Mediamaster.
•Connect a SCART cable between the VCR and the AUX SCART socket on the Mediamaster.
•Connect an RF cable from the RF output on the VCR to the TV aerial input on the TV.
•Connect an RF cable from the RF output on the analogue receiver to the RF input socket on the VCR.
•Connect the TV aerial to the RF input socket on the analogue receiver.
In order to switch the signal from the dish between the ana- logue and digital receivers, you need a Nokia smart switch (at A B in the diagram) or a Universal Twin LNB.
With Nokia smart switch
VCR
SCART
RF
Mediamaster
Analogue receiver
Nokia smart switch
• Connect a coaxial cable between output A on the smart switch
(accessory) to the LNB socket on the analogue receiver.
• Connect a coaxial cable between output B on the smart switch
to the ANTENNA socket on the Mediamaster. |
|
The analogue receiver must be switched OFF (in standby) | Nokia smart switch |
when you want to watch digital satellite channels from the |
|
Mediamaster. |
|
Connecting a HiFi system
•Connect an RCA/Cinch stereo cable from the AUDIO L R sock- ets on the Mediamaster to the LINE, AUX, SPARE or EXTRA input sockets on your HiFi system.
•If available you can connect an RCA/Cinch single cable from the DIGITAL AUDIO socket on the Mediamaster to your HiFi or Dolby Pro Logic system.
Note: To avoid interference you must use a screened audio cable.
Connecting to the built in phone modem
The modem function is only valid in Scandinavia.
The built in phone modem makes it possible for you to use inter- active services. Refer to page 48. This function is only imple- mented in boxes intended for the Scandinavian countries.
•Connect a telephone cable between the socket marked TELEPHONE on the rear of the Mediamaster and the ordinary telephone socket in the wall.
GB 10
