MAIN MENU
TV signal
If the teletext function does not work when watching channels from an analogue satellite receiver connected to the Media- master, change this setting from RGB to PAL.
RF channel
Select this alternative if you have to change the RF channel.
If you change the RF channel number, you must also change it to the same value on the TV. If you do not, the picture will become black.
RF modulator type
If the Mediamaster is connected to the TV by an RF cable, you can select the RF modulator type. The RF modulator affects a channel’s audio. If you get picture but no sound, the RF modula- tor selection might be wrong.
Select “Normal (PAL B/G)” for all countries except the UK. Select “UK (PAL I)” when the box is used in the UK.
Position of the RGB output
Adjust the horizontal position of the TV picture with the 
but- tons. (The “TV signal,” see above, must be set to RGB for this function to work.)
Time adjustment
The time is adjusted by using the 
buttons, ± 1/2 an hour at a time.
You can also adjust the minutes by using the 
buttons.
Modem Setting
The modem function is only valid in Scandinavia.
The Mediamaster is equipped with a built in telephone modem. Via the modem so called “interactive services”, such as e.g. or- dering movies, can be performed.
You will get more information concerning this service by your service provider. More information may also be available in the “System information” menu, ref. to page 54.
When configurating the modem, the following parameters have to be set.
Country: Select the country where the box is installed.
Pulse or tone: Select the alternative valid for your system. If in doubt, please contakt your phone operator.
Prefix: If the connection has to pass a switch board, enter the figure that will open the line.
The RF channel number will be in- dicated on the front display of the Mediamaster.
GB 48
