FIRST TIME INSTALLATION
Manual search
When you perform a Manual search you first need to enter some parameters for the channel search to work.
The information you need to enter in this menu is available in magazines covering satellite TV reception, on the Internet or from your Service Provider.
Transponder frequency: Specify the frequency in GHz. If you enter the wrong figure(s), erase with the 
button.
Polarization: Select Horizontal, Vertical, Circular left or Circular right.
Symbol rate (MSym/s): Enter with the numeric buttons. If you enter the wrong figure(s), erase with the 
button.
FEC: Select “Auto” or any of the preprogrammed values.
Network search: Select “Yes” if you want to search on all trans- ponders connected to a specific network.
Adjust motor: Adjust (if necessary) the motor for the current satellite.
Press OK to start searching for channels.
Advanced search
The information to enter in this menu is available in magazines covering satellite TV reception, or from your Service Provider.
You can use this menu if you are looking for some “special” chan- nels (i.e.
Transponder frequency: Specify the frequency in GHz.
Polarization: Select Horizontal, Vertical, Circular left or right.
Symbol rate (MSym/s): Enter with the numeric buttons.
FEC: Enter the appropriate Forward Error Correction (FEC) or select AUTO
PID Video: Enter the PID (Packet Identifier) for the video signal.
PID Audio: Enter the PID for the audio signal.
PID PCR: Enter the PID for the PCR (Programme Clock Refer- ence).
Adjust motor: Adjust (if necessary) the motor for the current sat- ellite.
Press OK to start searching for channels.
Motor antenna
In case you have an antenna motor to control your satellite an- tenna you have to make the following settings. If your antenna is prevented from reaching its east/west limit positions, you have to set these limits. See page 47 for instructions.
•From the “Antenna/Satellite selection” menu select line 7 and press OK.
•Select line 5, “Motor antenna” and press OK.
GB 19
