JVC CA-NXG9 manual Setting the Recording Timer, To cancel the Recording Timer, Select REC Timer

Setting the Recording Timer

•Finish the timer setting at least 2 minutes before the on-time.

•To exit the timer settings, press CLOCK/TIMER (while holding SHIFT) as required.

•To correct a mis-entry during process, press CANCEL (while holding SHIFT). You can go back to the previous step.

Preparation:

•Connect a USB mass storage class device to the USB 2 terminal.

•Change the source to “USB2” and check that the USB device is properly detected by the System.

•Make recording settings (see page 29).

1Select the timer setting mode.

3Turn off the System (on standby), if you have set the timer with the System turned on.

• Recorded files are stored into the group “Timer.”

To cancel the Recording Timer

1Select “REC TIMER.”

(while holding )...
	Recording Timer		Daily Timer
	REC TIMER	ON (Time)	DAILY	ON (Time)

Canceled

Clock setting

(while holding )...
	Recording Timer			Daily Timer
	REC TIMER		ON (Time)	DAILY	ON (Time)
		Canceled		Clock setting
				(See page 20.)

(See page 20.)

2Turn off the Timer.

(while holding...)

REC	ON 8:00	To turn on the Recording Timer
		1 Select “REC TIMER.”

2Set the timer as you like.

Repeat the procedure for the following settings until finished.

1Set the hour then the minute for on-time. 2Set the hour then the minute for off-time.

(while holding )...
	Recording Timer		Daily Timer
	REC TIMER	ON (Time)	DAILY	ON (Time)

3Select the recording source—“TUNER AM,”

Canceled

Clock setting

“TUNER FM,” or “AUDIO IN.”

4For “TUNER AM” or “TUNER FM”: Select a

preset channel.

5Select the volume level.

•You can adjust the volume level (“0” to “MAX” and “VOLUME – –”). If you select “VOLUME

– –,” the volume is set to the same level as when the System was last turned off.

Once settings are completed, the timer setting information appears in sequence.

(See page 20.)

2Activate the Timer.

3Wait until the indication disappears.

56