Introduction
Thank you for purchasing a JVC product. Please read all instructions carefully before operation, to ensure your complete understanding and to obtain the best possible performance from the System.
Precautions
Installation
•Install the System in a location with adequate ventilation to prevent internal heat
DO NOT install the System in a location near heat sources, or in a place subject to direct sunlight, excessive dust or vibration.
•Install in a place which is level, dry and neither too hot nor too
•Leave sufficient distance between the System and the TV.
•Keep the speakers away from the TV to avoid interference with the TV.
Power sources
•When unplugging the System from the wall outlet, always pull on the plug, not the power cord.
DO NOT handle the power cord with wet hands.
Moisture condensation
Moisture may condense on the lens inside the System in the following cases:
•After starting to heat the room
•In a damp room
•If the System is brought directly from a cold to a warm place.
Should this occur, the System may malfunction. In this case, leave the System turned on for a few hours until the moisture evaporates, unplug the power cord, then plug it in again.
Internal heat
•Make sure there is good ventilation around the System. Poor ventilation could overheat and damage the System.
DO NOT block the ventilation openings or holes. If they are blocked by a newspaper or cloth, etc., the heat may not be able to get out.
Others
Should any metallic object or liquid fall into the System, unplug the power cord and consult your dealer before operating any further.
DO NOT disassemble the System since there are no user serviceable parts inside.
•If you are not going to operate the System for an extended period of time, unplug the power cord from the wall outlet.
If anything goes wrong, unplug the power cord and consult your dealer.
How to Read This Manual
•Button and control operations are explained in the table below.
•Some related tips and notes are explained later in the sections “Learning More about This System”
and “Troubleshooting,” but not in the same
section explaining the operations ( 
indicates that the content has some information).
•Illustrations used in this manual is mainly of CA- NXG7. They may look different from the model you have.
Indicates that you press the button briefly.
Indicates that you press the button briefly and repeatedly until the option you want is selected.
Indicates that you press one of the buttons.
2sec. | Indicates that you press and hold the |
| button for a specified period. |
Indicates that you turn the control in the specified direction(s).
Indicates that this operation is only possible using the remote control.
Indicates that this operation is only possible using the main unit.
1
