JVC CA-NXG9 manual TV/monitor, ⁄ Digital audio component, Preparing the remote control

!TV/monitor

Connect either a component video cord, a composite video cord or a HDMI cable.

•To select progressive scanning mode (see page 7), use COMPONENT jacks or the HDMI MONITOR OUT jack.

•After connecting a TV, select the appropriate video signal output according to the color system. See “Changing the Color System and Scanning Mode” on page 7.

•When you use an HDMI cable, make appropriate settings in the SET UP menu (see page 58).

HDMI cable (not supplied) Use an HDMI cable of less than 2 m.

Composite video cord (supplied)

Yellow

Green

Red Blue

Component video cord (not supplied)

About HDMI CEC

CEC is device controlling signals optionally employed for the HDMI standard. When devices equipped with CEC are connected, each device can control the others. This System is compatible with some basic functions of HDMI CEC. For example, when you start playback on the System, the connected TV compatible with HDMI CEC automatically turns on.

•This function is available only when the source is set to “DVD/CD” or “USB1”.

•You can activate or deactivate this function (see page 58).

•For details about the CEC function, refer to the operations manuals of the connected CEC devices.

•The CEC function may not work with some CEC devices.

•The CEC function may not work depending on the settings or status of the System or the connected CEC devices.

⁄Digital audio component

Optical digital cord (not supplied)

Protective cap

•Set “DIGITAL AUDIO OUTPUT” in the “AUDIO” menu correctly according to the connected digital audio equipment (see page 66).

•The digital signal through the OPTICAL DIGITAL OUTPUT terminal is transmitted only when “DVD/ CD” or “USB1” is selected as the source.

@Voltage selector (only for CA-NXG9)

•This operation is not required for Saudi Arabian models and Australian models.

Use a screwdriver to slide the voltage selector so that it is pointing to the correct voltage in the area you are plugging in the unit. (See also the back cover page.)

Preparing the remote control

Insert the battery into the remote control by matching the polarity (+ and –) correctly.

If the range or effectiveness of the remote control decreases, replace both batteries.

Caution:

Be careful your children do not put the batteries into their mouth.

When using the remote control

Point the top of the remote control towards the remote sensor as directly as possible. If you operate it from a diagonal position, the operating range (approx. 5 m) may be shorter.

6