Maintenance
To get the best performance of the System, keep your discs and mechanism clean.
Handling Discs
•Remove the disc from its case by holding it at the edge while pressing the center hole lightly.
•Do not touch the shiny surface of the disc, or bend the disc.
•Put the disc back in its case after use to prevent warping.
•Be careful not to scratch the surface of the disc when placing it back in its case.
•Avoid exposure to direct sunlight, extreme temperature, and moisture.
To clean the disc:
Wipe the disc with a soft cloth in a straight line from center to edge.
Cleaning the System
•Stains should be wiped off with a soft cloth. If the System is heavily stained, wipe it with a cloth soaked in
•Since the System may deteriorate in quality, become damaged or get its paint peeled off, be careful about the following:
–DO NOT wipe it with a hard cloth.
–DO NOT wipe it forcefully.
–DO NOT wipe it with thinner or benzine.
–DO NOT apply any volatile substance such as insecticides to it.
–DO NOT allow any rubber or plastic to remain in contact for a long time.
Troubleshooting
General
Adjustments or settings are suddenly canceled before you finish.
]There is a time limit. Repeat procedure again.
Operations are disabled.
]The
Unable to operate the System from the remote control.
]The path between the remote control and the remote sensor on the System is blocked.
]The batteries are exhausted.
No sound is heard.
]Speaker connections are incorrect or loose.
]Headphones are connected.
No picture appears on the TV screen.
]The video cord connections are incorrect or loose.
No picture is displayed on the TV screen, the picture is blurred, or the picture is divided into two parts.
]The System is connected to a TV which does not support progressive video input.
]Incorrect scanning mode is selected (see page 7).
]When you unplug the power cord and plug it back again, the scanning mode may change back to the initial setting (see page 7).
The left and right edges of the picture are missing on the screen.
]Select “4:3 LB/4:3 MULTI LB” for “MONITOR TYPE” (see page 57).
Radio Operations
Hard to hear broadcasts because of noise.
]Antenna connections are incorrect or loose.
]The AM loop antenna is too close to the System.
]The FM antenna is not properly extended and positioned.
Disc/USB mass storage class device Playback Operations
The disc does not play.
]You have inserted a disc whose Region Code is not correct. (“REGION ERR” appears on the display.)
]The disc is placed upside down. Place the disc with the label side facing up.
ID3 Tag on an MP3 file cannot be shown.
]There are two types of ID3
Groups and tracks are not played back as you expect.
]The playing order is determined when the groups and tracks were recorded. It depends on the writing application.
63
