If using Playback Special Effects, press EFFECT (pg. 41).

44EN

USINGTHEREMOTECONTROLUNIT(cont.)

Programme

 

 

 

 

 

 

 

 

I N

OUT MODE

 

1

– – – – : – – ~

 

2

3~

4~

5~

6~

7~

8~

TIME CODE

– : – –

4

TOTAL

0 0 : 0 0

 

Random Assemble Editing Menu

SELECT SCENES (cont.)

6 At the beginning of the scene, press EDIT IN/OUT on the remote control. The Edit-In position appears in the Random Assemble Editing Menu.

7 At the end of the scene, press EDIT IN/OUT. The Edit-Out position appears in the Random Assemble Editing Menu.

Remote sensor

RM-V711U

(provided)

T

W

 

 

FADE/WIPE

 

PLAY

EFFECT

 

 

 

EDIT IN/OUT

 

R.A.EDIT

 

 

ON/OFF

8 If using a Fade/Wipe at the end of the scene, press FADE/WIPE.

•Cycle through the effects by pressing repeatedly, and stop when the one you want is displayed.

•If you select a Fade/Wipe effect for an Edit-Out point, the effect is automatically applied to the following Edit-In point.

•You cannot use a Picture Wipe/Dissolve at the end of the last scene.

•When you use Fade/Wipe effects, that time is included in the total time (this does not apply to Picture Wipe/Dissolve).

9

10 Repeat steps 6 through 9 to register additional scenes. •To change previously registered points, press

CANCEL on the remote control. The registered points disappear, one at a time, from the most recently registered point.

•If you are not using Fade/Wipe or Programme AE with special effects, repeat steps 6 and 7 only.

CANCEL

NOTES:

When choosing a scene, set Edit-In and Edit-Out points so that there is a relatively large difference between them.

If the search time for an in-point exceeds 5 minutes, the recording deck’s Record-Standby mode will be canceled and editing will not take place.

If there are blank portions before or after the Edit-In and Edit-Out points, a blue screen may be included in the edited version.

Since time codes register time only as accurately as seconds, the time code total time may not match the total programme time exactly.

Turning off the camcorder’s power erases all registered Edit-In and Edit-Out points.

If you select Sepia or Monotone mode from Programme AE with special effects, you cannot use the Dissolve or Black & White Fader. In this case the Dissolve or Black & White indicator begins blinking. Once the next Edit-In point is registered, the effect is turned off. To combine these effects, use Sepia or Monotone during recording, then use the Dissolve or Black & White Fader during Random Assemble Editing.

It is not possible to use Fade/Wipe effects and Programme AE with special effects during Random Assemble Editing using a DV cable.

Page 44
Image 44
JVC GR-DVL28, GR-DVL33, GR-DVL48, GR-DVL38 specifications 44 EN, Select Scenes