JVC GY-DV550U instruction manual Rear Section

2. CONTROLS, INDICATORS AND CONNECTORS

2-6 Rear Section

o

t

y

q	DV LINE	MIC	LINE	MIC	INTERCOM
		+48V		+48V
		ON		ON
w	EARPHONE			FRONT		DC INPUT
			AUDIO IN
	DC			REAR
	OUTPUT
e
		r			u	i

1[DV] connector

Using a DV cable (optional), a digital video component with DV connector can be connected here.

This connector is used for output of the DV signal or to input the VCR control signal from the digital video component with DV connector.

•To remote control the VCR with a VCR control signal from this connector, set the VCR Setup Menu item No. 050 REMOTE SELECT to "IEEE1394".

2[EARPHONE] earphone jack

This is a mini-jack for connecting an audio monitoring earphone. Plug in an earphone or headphone with a 3.5 mm diameter plug. Audio is outputted in monaural.

The earphone can also be used to monitor alarm tones depending on situations.

The sound from the monitoring loudspeaker is interrupted when an earphone is connected here.

3[DC OUTPUT] connector

Power output connector to a wireless microphone transmitter, etc. The supply voltage is identical to the voltage supplied to the unit (DC 12V max. 0.1 A).

!0

PUSH

DV CAMCORD

VTR/RM

GY-DV550

PROMPTER

OUTPUT

Y/C OUT MONITOR OUT	LINE OUT
	CH-1	CH-2
		!1
		REMOT
TC IN	TC OUT

BREAKER

Bottom side

4[AUDIO IN REAR] audio input rear connector (XLR 3-pin)

Connect the external audio equipment or microphone to this connector. Set the AUDIO IN REAR LINE/MIC select switch 5 according to the connected equipment.

To record the audio of this connector, set the CH-1 AUDIO INPUT switch 7 or the CH-2 AUDIO INPUT switch 8 on page 14 to "REAR".

(AUDIO IN connector)

No. Signal

1GND

2 1 2 HOT

33 COLD

5 [AUDIO IN REAR LINE/MIC] AUDIO IN REAR select

switch

Selects the audio signal input to the 4 AUDIO IN REAR

connector.

LINE : Set to this position when connected to audio

equipment, etc. The reference input level is +4 dBs.

41

32

(Surface profile)

No. Signal

1GND

2—

3—

4DC +12V (power through)

MIC : Set to this position when the microphone is

connected. The reference input level is -60 dBs.

MIC +48V ON:

Set to this position when the microphone requiring

+48 V power supply (phantom microphone, etc.) is connected.

This connector supplies +48 V DC current.

22