JVC GY-DV550U Connecting the camera remote control unit, Back Tally lamp, VTR/RM connector

13. FEATURES OF THE CAMERA SECTION

13-8 Connecting the camera remote control unit

	BACK TALLY lamp
				1. MODE
				switch
ATE/WARNING						VTR/RM connector
	LIGHT		MODE
	ON
	OFF		RM
			VTR
	COUNTER		INCOM
	CTL		MIC
	TC	CARBON
	UB	DYNAMIC
		INCOM
		MIC	LEVEL
		ON
AUTO	FRONT
MANUAL	REAR
AUDIO SELECT	AUDIO INPUT	OFF
O CH-2		CALL
EL
		RM	OFF	DC IN
				/BATT.
			POWER
				DV LINE MIC	LINE MIC	INTERCOM
				+48V	+48V
				ON	ON
				EARPHONE	FRONT	DC INPUT
					AUDIO IN
				DC	REAR
				OUTPUT
4. INCOM MIC				3. INCOM MIC	INTERCOM
				switch
switch		2. POWER switch			connector
						Headset

Headset

Camera remote control unit

The unit can be remotely controlled using the camera remote control unit. Use the following available products.

Camera remote control unit

•RM-P200 ...............Maximum cable length is 100m.

(Not available for 4-inch viewfinders.)

CAUTION:

To use the camera remote control unit RM-P200, internal adjustments of the RM-P200 are required. It is, therefore, mandatory that you contact the nearest JVC-authorized service agent for inquiry about the adjustments.

•RM-P300 ...............Cable length is 200m only.

Intercom headset

•KA-310

Connection

●Connect the camera remote control unit to the VTR/RM multi-pin connector.

●When using the intercom headset, connect the headset to the INTERCOM connector.

●To check the prompter output of the camera remote control unit, connect a monitor to the PROMPTER OUTPUT connector.

Settings

1. Set the MODE switch to RM.

2. Select the power source of this unit using the POWER switch. When supplying power from the power supply of the camera remote control unit through the VTR/RM multi-pin connector, set the POWER switch to RM.

3. Set the INCOM MIC setting switch according to the intercom headset microphone type (carbon-type or dynamic-type microphone).

4. Use the INCOM MIC switch to set whether to use the microphone of the intercom headset.

•The microphone of the headset will become available for use when setting to ON and the volume can be adjusted by turning the volume knob.

5.Composite video signals of the camera are constantly outputted from the VTR/RM multi-pin connector. Other than this signal, another type of video signals can be outputted. The output signal is selected in 26 PIN OUT of the Camera SETUP menu screen.

(Y/C, RGB or component video signal)

Memo:

•External input video signals will not be outputted from the VTR/RM multi-pin connector even when setting the VTR INPUT switch to AUX.

•Playback video of the VCR will not be outputted from the VTR/RM multi-pin connector.

•Call signals will be sent to the operator of the camera remote control unit while the CALL button is held down. During this time, the BACK TALLY lamp will blink. The BACK TALLY lamp will blink when the call signal is received.

•The screen will distort when inputting sync signals to both the main unit and camera remote control unit.

•When the power is set to ON during input of external synchronous signals, the screen may shift vertically for a few seconds; however, this is not a malfunction of the unit.

•Read the instruction manual of the camera remote control unit for the correct usage.

94