If the number you entered | ||
is not in the VCR's memory | ||
(if you made a mistake), the | ||
NO DIRECTORY | ||
screen to the right appears: | ||
AVAILABLE FOR TAPE#0123 | ||
| ||
| ||
| ||
| PRESS(CANCEL)TO RETURN | |
| PRESS(INDEXPlus+)TO EXIT |
Press CANCEL, or wait a few seconds, and the TAPE
#screen reappears. Reinput the Tape Number. Go to step 6.
ATTENTION
If you don't input the Tape Number within 1 minute after the first screen in step 3 first appears, a Tape Number will automatically be assigned. That means that tape will have two numbers. Be sure to input your Tape Number as soon as possible.
4Start recording. Since a Tape Number has already been assigned, no further operations are necessary.
5Start recording. A Tape Number is automatically assigned. Go to step 6.
6 Once recording is finished, press STOP/ EJECT to take the tape out. When ejecting a tape for which you've just entered a tape number, or a tape to
which a number has just been automatically assigned, the display to the right appears:
IMPORTANT
Before you press ENTER to clear the screen, write the tape number (if newly assigned or not recorded) on the tape label. This will help to eliminate accidents and confusion later.
NOTES:
●If the recording time is particularly short, the data may not register in the library and a tape number may not be assigned.
●When recording onto a
●When recording over a tape made on another INDEX Plus+ VCR, old directories remain. This may inhibit the making of new directories.
●During recording, if you press INDEX Plus+, the Tape Number, tape position and program title appear on screen (if the VCR was able to read the Tape Number, tape position and program title).
●After recording ends, "PLEASE WAIT A MOMENT" appears on screen for a few seconds. No operations can be performed until the message disappears.
INFORMATION:
In the case of a tape that has accidentally been assigned multiple Tape Numbers, perform the following consolidation procedure:
1.Insert the tape, and the VCR reads the Tape Number at the current tape position. (Refer to page 13 of this instruction manual.)
2.Find a location on the tape where another Tape Number is recognized, play the tape back for a few seconds and press INDEX Plus+.
3.The directory appears, and program titles that appeared separately under different Tape Numbers are combined into one listing, under the older number.
4.If the tape has more than two Tape Numbers, repeat steps 2 and 3 for each additional number.
ATTENTION:
When this VCR's memory becomes full, you cannot register any more directories. Be sure to occasionally check the status of memory. When it becomes full, cancel unnecessary directories. (Refer to "Erasing A Directory" on page 21 of this instruction manual.)
Use the following procedure to check the status of memory.
1. Turn on the power to the TV and the VCR.
2. Set the TV to the channel or mode appropriate for video playback.
3. Insert an HR tape.
4. Press INDEX Plus+. The tape's directory appears.
5. Press F3.
6. The screen to the right appears. At the bottom of the screen, the amount of memory currently being used is shown. It begins blinking when there's no memory space open.
15
