JVC HR-XV1EK manual DVD Picture Signal Selection/Zooming

DVD Picture Signal Selection/Zooming

You can select the output signal of DVD playback picture to the TV screen as an VIDEO signal or a RGB signal.

Preparation:

•Turn ON the TV and set to the video input mode.

•Make sure TV/VCR/DVD switch has been slided to VCR/DVD. Then press DVD to select the DVD mode. (The DVD indicator will light)

1

2

Press SET UP MENU in the stop mode.

Press or to select “Pic-

ture”, then press or to select “Video Out Select”.

Press OK (Enter).

Press or to select the desired picture signal, “Video” or “RGB”.

ABC

Picture

TV Shape 4:3LB

Video Out Select Video

: Select : Enter

ABC
Picture
TV Shape 4:3LB	Video
Video Out Select Video	RGB

: Select : Enter

3 To make SETUP screen disappear, press SET UP MENU.

Notes:

•If you use the connection with S-Video cord, be sure to set the “Video Out Select” at step 2 above to “Video”. If you select “RGB”, the TV screen will be disturbed.

•If you selected “RGB” at step 2 above, press TV/VCR to select VCR. (VCR indicator will appear on the display) Otherwise, the TV screen will be disturbed when you select the channel with TV’s CHANNEL UP/DOWN buttons.

Zooming

This unit will allow you to zoom in on the frame image. You can then make selections by switching the position of the frame.

Note:

1 Press ZOOM during playback. The centre part of the image will be zoomed in.

As you repeatedly press the OK or ZOOM while “ZOOM” is selected, the magnification level changes. Variation of the levels includes image reduc- tion.

ZOOM

EXIT

Zoom Off

: Select : Change

•Picture Signal Selection is only available for connecting with a 21 pin Scart Cable.

•Depending on your TV, NTSC disc may not playback correctly in colour. In this case, it is recommended to select the Picture Signal RGB on step 2.

•Only use RGB setting if your TV is RGB compatible.

40

2 Press / or / to view a different part of the frame. You may move the frame from the centre position to UP, DOWN, LEFT or RIGHT direction.

•If you select “EXIT” and press the OK, you can turn off the symbol mark, keeping the current magnification level.

•Press CANCEL to restore the zoom point to the centre of the picture.

3 While “ZOOM” is selected, press ZOOM repeatedly to re- turn to a 1:1 view.