|
| Remote control |
How to install the batteries |
|
|
Use micro batteries type AA. |
|
|
1 Open the battery compart- | 2 Install two "AA" batteries (not | 3 Replace the compartment |
ment cover in the direction of | supplied), paying attention to the | cover. |
the arrow. | polarity diagram in the battery |
|
| compartment. |
|
Battery precautions
The precautions below should be followed when using batteries in this device:
1.Use only the size and type of batteries specified.
2.Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage to the device. To avoid a potential short circuit, insert the
3.Do not mix different types of batteries together (e.g. Alkaline and
4.If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.
5.Do not try to recharge batteries not intended to be recharged; they can overheat and rupture.
Distance of Remote
Control Operation
approx.
5m
Effective angle: approx. 60°
Point the remote control directly at the remote sensor.
Change the custom code for remote control
If you operate this DVD/VCR with another JVC’s VCR simultaneously arranging them side by side, the both recorders will react to this remote control. In this case, you can change the remote control and DVD/VCR to other frequency (“ 
”). Then you can operate only this DVD/VCR with this changed remote control.
When you purchased, the DVD/VCR and remote control have been set to the 
”.
Example: Change frequency to 
Remote control:
While holding VCR, press 2 (code: b) of Number keys.
(in case of code: A, press 1). Then press OK.
DVD/VCR:
In the POWER off mode, press and hold PLAY for more than 5 seconds. The current code (“A” or “b”) will appear on the display. Then press 3 on the remote control. The current code of the remote control will be transmitted to the unit and the unit will be adjusted to the transmitted code. Then the code will disappear after approx. 4 seconds.
NOTE:
•If the remote control has been set to b, the DVD/VCR also must be set to b. Otherwise, the DVD/VCR can not be operated with this remote control.
•To reset to “A”, repeat above procedure. However press 1 instead of 2.
9
