JVC KY-F70 manual Mounting the lens, E17, Camera head Male Thread section Mount clamp ring Lens

Mounting the lens

Follow the procedure shown below when mounting an auto-iris lens. For further details, see the instruction manual of the lens.

Camera head 3. Male

Thread section Mount clamp ring

Lens

2.

-F70 KY

CAMERA

DIGITAL

C-MOUNT

Female

Lens remote control

1. Remove the lens mount cap. At this time, take caution so that dust do not enter inside the mount.

2. To mount the lens, lightly press the thread section of the lens mount onto the thread section of the main unit, then turn the mount clamp ring slowly clockwise until it is securely tight- ened.

MEMO

To change the position of the lens rotation:

aFirst, turn the mount clamp ring counterclockwise (1/4 turns) with the lens facing you. b Slowly turn the lens and after adjusting the position, retighten the mount clamp ring.

3.Insert the camera cable of the lens into the lens connection terminal on the rear of the main unit, then securely fasten.

The iris control is made automatically from the camera.

*When using a manual iris lens, set the IRIS MODE to MANUAL (see ☞ page 48).

4.When using the lens remote control, connect the lens control cable (female) to the remote control.

CAUTION

Lens is not included with this unit.

4mm or less

To avoid damaging the main unit, make sure that the lens mount of the lens to be

used is 4mm or less.

Lens

E17