Connecting a printer
It is possible to directly output image data stored in the main unit memory to a printer. ( ☞ page 37 Outputting images from the memory to a printer)
PAPER FEED 
& CUT ]
ALARM SHEET PAPER DATA
POWER
CP700DSA MITSUBISHI
COPY 
ONLINE 
OPEN 
Dip switches
SCSI
SEND | REC |
AW/SEL MODE | |
MENU UP | DOWN SET |
| PLAY |
| FREEZE |
MONITOR | LENS |
REMOTE | DC IN |
ON 1 2 3 4 | POWER |
SEE INSTRUCTION MANUAL
SCSI terminal
When directly connecting the main unit to a printer, set the dip switches on the rear of the main unit as shown below.
ON 1 2 3 4
(SCSI : 7)
Set the ID of the printer side to other than 7.
MEMO
•The image data outputted to a printer will be 1360 × 1024 pixels, regardless whether the monitor in use is VGA or SXGA, or whether the VGA mode is set to FINE or DRAFT.
•The maximum allowed length of the SCSI cable is 3m.
•When connecting an MO drive to a PC, separate setting of the SCSI ID is required. ( ☞ Page 64 7. Connecting to a PC)
•It is not possible to simultaneously output the image data to a printer and MO drive.
