28 EN
VIDEO CAPTURE
(cont.)
INTERVAL CAPTURE

The Interval Capture mode is best suited for

capturing images at set intervals from a video

source unit with a JLIP connector.

Preparation
•Make sure all units are properly connected
(Z p. 12).
•Insert a tape into the video source unit.
Click "Image Format" in "Set-up" and select
"Field Picture" in the Capture Mode.
(Z p. 29).
1
Open the menu bar and click "Set-up" —
"Capture Mode" — "Automatic".
•The "Automatic Transfer" window
appears.
2
Select the data to be transferred.
•When you select "Index Image", index
image data (80 x 60 pixels) is transferred
to your computer.
•When you select "Index & Full Image",
both index image data (80 x 60 pixels)
and full image data (768 x 552 pixels) are
transferred to the computer.
3
Select "Interval Capture".
4
Set the interval.
•Select the time interval at which pictures
are captured.
5
Set the number of pictures to be captured
and click "OK".
•From 1 up to 99
6
Click "Window" — "VCR" to call up the
VCR Operation Window. Start video
playback a few seconds prior to the point
where you want image capturing to start.
7
Operate the video source unit via the VCR
Operation window and click the "Transfer"
button at the desired picture.
1. The message "No. 1 index image being
transferred" appears while the index image
data is being transferred to the computer.
2. When you select "Index & Full Image" in
step 2, the message "No. 1 full image being
transferred" appears while the full image
data is being transferred to the computer.
3. The message "Index No. 2 being scanned"
appears while the video data are fast-
forwarded and played at the time intervals
set in step 4 to scan the video data on the
VCR.
• The image selected when "Transfer" is
clicked is captured and subsequent images
are captured at the time interval specified
by the counter value selected in step 4.
• The video source unit enters the Pause
mode when capture is complete.
Set-up
Capture Mode
Image Format
Device Change
Initialize
ID Change
Counter Reset
Step by Step
Automatic
00:01:23:12F
I
VCR
Capture
Transfer

NOTE:

•Make sure that enough hard disk space is
available on your computer before
executing video transfer.
For full image data space requirements,
Z p. 24.

•Transfer of index image data/full image

data starts at the image box bordered in

green.

Click and select the desired image box.

•When transferring full image data using

the Bitmap image format (9.bmp), the

transfer takes a very long time, causing

the video source unit to stop playback

automatically.