JVC SR-9240EK appendix Alarm/sensor, Recording mode, RS-232C, Parameter

5 SETTING OF THE FUNCTION MENU SWITCHES

5-2 Contents of the Function Menu Switches

[ ]: Factory setting

Screens		Items	Set values				Function
VTR mode 2	COUNT END		[OFF]	Sets the timing to process tape end at a specified counter value rather than at
setting			500	the actual tape end. This menu switch setting is effective in the 48H to 240H
			1000	Record modes. For the 3H to L24H modes, set with <REC REMAIN>. The
			:	following operations are executed at the timing set with this menu switch.
			:	• The tape end signal is output from the rear panel's [TAPE END] terminal.
			9500
				• The series recording signal is output from the rear panel's [CLOCK/SERIES
					OUT] terminal (with the TERMINAL SEL 1> function menu switch set to
					"SERIES").
				•	The tape end buzzer sounds (with the <TAPE END BUZZER> function menu
					switch set to "ON").
				•	"End" is shown on the counter display.
				OFF: Executes tape end processing at the actual tape end.
				5000 - 9500: Executes tape end processing at the set tape counter value.
				To determine the set tape counter value according to the tape length, refer to
				the table on page 53.
Alarm/sensor	ALARM REC		[OFF]	Turns the alarm recording function on or off.
recording mode			ON	Alarm recording is enabled only in the Timelapse Record mode.
setting				An index code (VISS signal) is also recorded at the start point of alarm
				recording as an alarm cue signal.
				OFF : Alarm recording is disabled.
				ON		: This unit enters the VHS SP Record mode, when an alarm signal is input
						to the rear panel's [ALARM IN] terminal during timelapse recording.
	SENSOR REC		[OFF]	Turns the sensor recording function on or off. Sensor recording is enabled in
			ON	the Stop mode. An index code (VISS signal) is also recorded at the start point of
				sensor recording.
				OFF : Sensor recording is disabled.
				ON		: When an alarm signal is input to the rear panel's [ALARM IN] terminal in
						the Stop mode. this unit automatically starts recording in the VHS SP
						Recrd mode.
	DURATION		5	Selects the recording duration for alarm recording or sensor recording.
			15	5 ..... 180 : Alarm or sensor recording is performed for the time specified (5 sec.
			30				to 180 sec.).
			60	TAPE END: Alarm or sensor recording continues until the tape ends.
			120	MANUAL			: Alarm or sensor recording continues for as long as alarm signals
			[180]				are input.
			TAPE END				Set to this position when specifying the alarm recording time with a
			MANUAL				switcher.
	BUZZER		[OFF]	Selects whether or not the alarm buzzer sounds during alarm or sensor
			ON	recording.
				OFF : The buzzer does not sound.
				ON		: The buzzer sounds.
	TAPE END		[STOP]	Set the operation mode at tape end during recording in the case when alarm or
	MODE		REW	sensor recording is executed even once.
			REPEAT	STOP			: Stops at tape end.
			EJECT
				REW			: Rewinds the tape automatically and stops.
				REPEAT			: Rewinds the tape automatically to the beginning and restarts
							recording.
				EJECT			: The tape is ejected.
RS-232C
		This screen is displayed on the on-screen mode setting screen only when the (optional) RS-232C
parameter
		board SA-K97U is installed.
setting
	BAUD RATE		1200	Select the RS-232C data transfer speed from 1200 bps, 2400 bps, 4800 bps or
			2400	9600 bps.
			4800
			[9600]

22