JVC SR-VS30U manual Recording, Controller during timer recording, Contact JVC toll free at

Filename [VS30U_1a-EN.fm]
VS30U_1a-EN.fm Page 25 Thursday, January 31, 2002 3:35 PM	Masterpage:Right-NoTitle0

		EN 25
		NOTES:
G Access the DBS Receiver Brand Set screen.
		● The Controller may not work with all types of DBS receiver.
Press OK or e.		● If your DBS receiver does not respond to the code, you cannot
		use the Controller to change satellite channels. In this case,
		make sure to leave the DBS receiver turned on and tuned to
H Enter the DBS receiver’s brand.		the proper channel before the scheduled start time of timer
		recording.
Press the appropriate number		● The VCR can only change the satellite channel through the
		Controller during timer recording.
keys to enter the brand code		● If your DBS receiver cannot be operated with a Remote
from the following list, then		(because it has no remote sensor), you cannot use the
press OK or e.		Controller to change its channels. Make sure to leave the DBS
The program currently		receiver turned on and tuned to the proper channel before the
received through the DBS		scheduled start time of timer recording.
receiver appears for about 10		● If the VCR’s memory backup expires because of a power
		failure, set the cable box output channel and brand again.
seconds.
		● For customers in U.S.A.: If you are unable to set the Controller,
		contact JVC toll free at 1-800-537-5722.
BRAND NAME	CODE
JVC (DISH Network)	51
ECHOSTAR (DISH Network)	51
SONY (DSS)	41
RCA (DSS)	40

If the DBS receiver’s channel changes to the channel listed below for your brand, setting is complete.

JVC ] 100 ECHOSTAR ] 100

SONY ] 205 RCA ] 205

Press OK or e and “DBS RECEIVER CONTROL IS ON” appears on the screen for about 5 seconds, then it returns to the normal screen.

If the DBS receiver’s channel does not change as shown above;

APress rt to move the highlight bar (arrow) to “NO”, then press OK or e.

BRepeat step 8.

Page 25

January 31, 2002 3:35 pm