Filename [VS30U_3-EN.fm]
Masterpage:Left
66 EN
Page 66 February 23, 2002 6:02 pm
REMOTE CONTROL FUNCTIONS
Remote A/B Code Switching
This Remote is capable of transmitting two control codes; one set
to respond to A code control signals and another set to respond
to B code control signals. This Remote control is preset to send A
code signals because your VCR is initially set to respond to A
code signals. You can easily modify your VCR and the Remote to
respond to B code signals. When using two JVC VCRs, set two
VCRs and their Remotes to different codes, so that you can
operate these VCRs separately.
ASet the remote control code for Remote.
APress and hold A/B.
BPress the number key “2”.
CPress STOP (8), and release A/B.
●The Remote now can transmit B code control signals.
BCheck the remote control code for VCR.
Press and hold PLAY(4) on the VCR for more than
5 seconds while the VCR is turned off. The code currently
set appears on the display panel.
CChange the code for VCR.
Press any key on the Remote. The VCR now responds to
B code control signals.
●To set the Remote and the VCR back to A code control signals,
repeat the same procedure as shown above except pressing
the number key “1” in step B of 1.
To control two VCRs with the same Remote
You can control two JVC VCRs by switching the remote control
code for the Remote between A and B (墌 step 1), keeping two
VCRs to different control codes.
●To change only the remote control code for the Remote, DO
NOT perform steps 2 and 3.
123
456
789
0
2
4
1
3
T W
DV S-VHS
132
VS30U_3-EN.fm Page 66 Saturday, February 23, 2002 6:02 PM