JVC SR-VS30U manual Programing, Select the deck, Access the PlusCode No. screen

Filename [VS30U_2-EN.fm]

VS30U_2-EN.fm Page 42 Saturday, February 23, 2002 5:57 PMMasterpage:Left

42 ENTIMER RECORDING

VCR Plus+® Timer	A	Turn on the VCR.
Programing	Press POWER.
	B
		Load a cassette.

With the VCR Plus+ system, timer programing is greatly simplified because each TV program has a corresponding code number which your VCR is able to recognize.

Before performing the VCR Plus+ Timer Programing:

●Make sure that the VCR’s built-in clock is set properly.

●Turn on the TV and select the AV mode.

Insert a VHS (or S-VHS) cassette with the record safety tab intact.

OR

Insert a Mini DV cassette with the erase protection switch set to “REC”.

C Select the deck.

Press S-VHSor DV.

T	W	3
1	2
		2
4	5	6
7	8	9
	0	4
1	DV	S-VHS

D Access the PlusCode No. screen.

Press PROG.

●The clock must be set to access

the PlusCode No. screen. If you have not set the clock, the Main Menu screen appears after an error message is displayed. Refer to “Plug & Play Set” ( pg. 14) or “Clock Set” ( pg. 16).

E Enter the PlusCode number.

Press the number keys to enter the PlusCode number of a program you wish to record. Then press OK.

●If you make a mistake, press

CANCEL and input the correct number.

F Access the VCR Plus+ Program screen.

The VCR Plus+ Program screen appears (if you’re just starting out and you have selected the VHS deck, “VHS PROGRAM 1” appears).

IMPORTANT

Make sure the channel position number you wish to record is displayed; if not, see “Changing VCR Plus+® Setting” on page 44 and set the Guide Channel number correctly.

●If the number you entered is invalid, “ERROR” appears on the TV screen. Press CANCEL and input a valid PlusCode number.

●If the “GUIDE CHANNEL SET” screen appears, see “ATTENTION” on page 43.

Page 42

February 23, 2002 5:57 pm