Masterpage:Right-NoTitle0
EN 51
Filename [VS30U_2-EN.fm]
Page 51 January 31, 2002 3:37 pm
When programs overlap each other
If “PROGRAM NOT COMPLETED PROGRAM OVERLAP”
appears, you have another program overlapping the program
you have just made.
The Program Check screen appears and conflicting programs
will start blinking.
Example: Program 1 (you have just made) and Program 4
overlap each other on the VHS deck.
AConfirm the overlapping programs.
Overlapping programs blink on the TV screen.
BSelect the program to modify.
Press rt, then press OK or e.
●You can only select one of the overlapping programs.
NOTE:
If you do not mind this overlap, press PROG to finish the timer
program setting. See “ATTENTION” in the left column. The
program with the lower program number will be recorded and
the other one will not be recorded correctly. If no changes are
made for approximately 3 minute, the VCR will return to the
normal screen.
CCancel or change program setting.
To cancel a program, press CANCEL when the Program
screen you do not want is shown. “PROGRAM
COMPLETED” appears on the TV screen for about 5
seconds, then the normal screen appears.
To change a program, press the appropriate button:
START+/–, STOP+/–, DATE+/–, CH+/–, and/or SP/EP
(p) when the Program screen on which you want to
make changes is shown, then press OK. “PROGRAM
COMPLETED” appears on the TV screen for about 5
seconds, then the normal screen appears.
NOTE:
If the overlap is not yet solved, or another overlap occurs with
the timer program setting after making the last correction on a
program, the conflicting programs will be shown on the Program
Check screen again. Repeat the above steps again until the
overlap is solved.
ATTE NT IO N
If there is a conflict in the timer schedule and one
program overlaps with another, only the parts shown
below in gray will be recorded.
Pattern 1: The program with the lower program number
will be recorded.
Pattern 2: The program starting earlier will be recorded.
Pattern 3: The program starting earlier will be recorded,
followed by the remaining portion of the other
program.
ATTE NT IO N
If the program you have
just made and “DV” are
blinking, there is a
conflicting program on the
DV deck.
APress rt to move the
highlight bar to “DV”,
then press OK or e.
DV Program Check
screen appears.
BCancel or change
program setting as
described in step 2 and
3 in the right column.
Program 1
Program 2
CH10
CH40 Not recorded
Not recorded
Program 1
Program 2
CH10
CH40
10:00 11:00 12:00
Not recorded
Program 1
Program 2
CH10
CH40
VS30U_2-EN.fm Page 51 Thursday, January 31, 2002 3:38 PM