Filename [VS30U_1a-EN.fm]
Masterpage:Left
24 EN
Page 24 January 31, 2002 3:35 pm
INITIAL SETTINGS (cont.)
Setting DBS receiver's brand and
channel
After installation, set the DBS receiver’s brand and
channel correctly; otherwise, the Controller cannot work
correctly.
ATurn on the VCR.
Press POWER.
BTurn on the DBS receiver.
Turn on the DBS receiver’s power.
CAccess the Main Menu screen on the VCR.
Press MENU.
DAccess the Initial Set screen.
EAccess the DBS Receiver Set screen.
FSelect the DBS receiver’s channel.
Your selection depends on how
the DBS receiver is connected
to your VCR.
If the DBS receiver is
connected to your VCR’s
ANTENNA IN connector on
the rear panel, press rt until
the channel number
representing the DBS receiver’s output (CH3 or CH4)
appears on the screen.
If the DBS receiver is connected to your VCR’s AUDIO/
VIDEO IN connectors on the rear panel, press rt until
“ON L-1 (REAR)” appears on the screen.
If you do not use a DBS receiver, press rt until “OFF”
appears on the screen.
Turn on the TV and select the AV mode.
123
456
789
0
2
4
1
3
T W
DV S-VHS
Press rt to move the
highlight bar (arrow) to
“INITIAL SET”, then press OK
or e.
Press rt to move the
highlight bar (arrow) to “DBS
RECEIVER SET”, then press
OK or e.
VS30U_1a-EN.fm Page 24 Thursday, January 31, 2002 3:35 PM