JVC VN-C215VP4U Note：, MRotation Knob, Inside the camera, R Status indicator, OFall-preventionwire, N Rotation center mark, Q [RESET] Reset button

Introduction

Name and Function of Parts (continued)

Inside the camera

L

M

N

O

P

Q

R

S

T

U

L[10BASE-T/100BASE-TX(PoE)]10BASE-T/100BASE-TX terminal

This is a 10BASE-T/100BASE-TX terminal. It connects to the network via LAN cable. (A Pg. 26)

MRotation Knob

This knob rotates the lens section and adjusts the tilting of the image. (A Pg. 28)

N Rotation center mark

(A Pg. 28)

Lens section

(A Next page)b

a

Z

Y

X

MAC address

W

V

Q [RESET] Reset button

This is a button for rebooting the camera. Press this button and release within 5 seconds to reboot the camera. It takes about 1 minute for the camera to reboot. During startup, [RESET] button is disabled.

Note：

●Pressing the [RESET] button for 5 seconds or longer switches the camera to the service verification mode. Do not press the button for 5 seconds or longer.

OFall-prevention wire

It connects the base H to the dome cover E.

PCamera Fastening Screw 2

This secures the camera unit T and the base H. How to remove (A Pg. 17)

R Status indicator

This indicator appears blinking when the power is turned on and turns off when the camera startup is completed. Check the camera or the connected device if the indicator remains blinking when the camera is in use.

12