Removing the dome cover

1.Remove the dome cover

Loosen the dome cover fastening screws (x3) with the wrench (supplied) and remove the dome cover.

Memo

The dome cover is connected to the base via a fall-prevention wire.

Wrench (Supplied)

Fall-prevention wire

2.Remove the inner dome

The inner dome is secured by 3 claws. Remove the inner dome from the claws.

Note

Make sure you touch the metal surface of the [MONITOR] terminal to release the static electricity from your body. Static electricity may cause the camera to malfunction.

Inner dome

Claw (3 locations)

Mounting the base

Remove the camera unit from the base and mount the base to the ceiling or wall.

To mount on a wall, use the same procedures below but replace the word “ceiling” with “wall”.

Setup

If necessary, use the attached template to drill a hole (R30 mm, 1-1/8 inches) for mounting.

 

R30 mm

 

(1-1/8 inches)

Fall-prevention wire

 

(not attached)

 

Power cable,

Approx. 100 mm

alarm cable,

(3-7/8 inches)

heater cable

 

LAN cable

 

1.Remove the camera unit from the base

A Loosen the camera fastening screws (x2) with the screw driver.

B Remove the camera from the base while pressing in the two claws.

A

B

Claw (2 locations)

Camera unit

Base

17