Kathrein UFS 702sw, UFS 702si manual LNB settings, Path MENUMain menuInstallationLNB

Installation

VCR record

The VCR Scart socket has two different modes for automatic VCR recording with the timer function: Standard The video signal (pin 19 on VCR Scart socket)

to the VCR is always available.

Pin 8 on the VCR Scart socket (switching voltage) is switched as an input, meaning that when you press the playback button on your video recorder, your satellite receiver automatically switches the video and audio signals coming from the video recorder to the TV Scart socket via the VCR Scart socket and from there to the TV set.

For timer-controlled video recordings in standard mode you must enter identical start and end times on your video recorder and in the “Timer Programming” menu.

Sat Record The video output signal (pin 19) from the VCR is always available.

When a timer event is active i.e. when the unit switches to the channel to be recorded at the pre-programmed time,12 V is output at pin 8 of the VCR Scart socket.

A “Sat Record”-compatible video recorder detects this voltage and automatically switches to record.

When the timer recording is finished, pin 8 is switched back to input mode and is again ready to relay the VCR signal on playback.

LNB settings

	Path: MENU>Main menu>Installation>LNB
	{ON}	Default setting
	{OFF}	Operation without LNB signal (e.g. on special
		multi-subscriber systems)
In standby	{OFF}	Default setting
	On standalone systems only use the {OFF} setting, otherwise
	the receiver will also supply power to the LNB in standby.
	This may cause the power consumption of the receiver to
	increase from the typical value of 2 Watts to as high as
	10 Watts in standby.
	{ON}	The LNB voltage remains switched on in
		standby e.g. to supply power in an appropriate
		multi-subscriber system.

44