FCC WARNING

This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.

FCC NOTE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful interference to radio communications, if it is not installed and used in accordance with the instructions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

■Reorient or relocate the receiving antenna.■Increase the separation between the equipment and receiver.

■Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

■Consult the dealer or an experienced radio/ TV technician for help.■Contains Transmitter ModuleFCC ID : RKXCK5000NVIA■Contains Transmitter Module IC : 5119A-CK5000NVIA
IC (Industry Canada) NoticeOperation is subject to the following two conditions:(1)This device may not cause interference, and

(2)this device must accept any interference, including interference that may cause undesired operation of the device.

The term “IC: ” before the certification/ registration number only signifies that the Industry Canada technical specification were met.

Note de ‘IC (Industrie Canada

L’utilisation de ce dispositif est autorisée seulement aux conditions suivantes:

(1)Il ne doit pas causer d’interférence, et(2)l’utilisateur doit accepter tout brouillage,

y compris les interférences pouvant compromettre le fonctionnement de cet appareil.

L’expression “IC: ” avant le numéro d’homologation/enregistrement signifie seulement que les spécifications techniques d’Industry Canada ont été respectées.

2CAUTION

Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

In compliance with Federal Regulations, following are reproductions of labels on, or inside the product relating to laser product safety.

Kenwood Corporation 2967-3, ISHIKAWA-MACHI, HACHIOJI-SHI

TOKYO, JAPAN

KENWOOD CORP. CERTIFIES THIS EQUIPMENT CONFORMS TO DHHS REGULATIONS N0.21 CFR 1040. 10, CHAPTER 1, SUBCHAPTER J.

Location : Top Panel