Satellite Radio Tuner Control

Preparation : Only with the optional accessory Satellite radio tuner connected.■Press and hold for about 2 seconds to memorize the current channel.■Press briefly to recall memorized channel.
1Press SRC to select “SIRIUS” or “XM”.

2Press BAND repeatedly to select a band (SR1/ SR2/ SR3/ SR4 ; XM1/ XM2/ XM3/ XM4).

3Press 4 / ¢ to search for a channel. ■ You need to register to the service provider

to receive the service by Satellite Radio. Consult the service provider if “CALL … TO SUBSCRIBE” appears.

■ The radio may take a little time to start receiving after you select the Satellite Radio source.

■ If the signal reception fails, “ACQUIRING SIGNAL”/ “NO SIGNAL” appears.

Category and Channel Search1 Press to enter Category and Channel Search mode.

2Turn the volume knob to select a category, then press to confirm.

3Turn the volume knob to select a channel, then press to confirm.

■ To return to the category select, press .

■To cancel the Category and Channel Search

mode, press and hold .
Channel Scan

1Press and holdto start Channel Scan. Every receivable channel is checked for 10 seconds.

2Pressto receives the current channel.

Direct Access Tuning using the remote controller (RC-405)

1Press DIRECT to enter Direct Access Tuning mode.

“– – –” appears.

2Press the number buttons to enter the channel number.3Press 4 / +¢ to search for the channel.■To cancel the Direct Access Tuning mode, press .

■If you make no button operation for 10 seconds, the Direct Access Tuning mode is automatically canceled.

■If you cannot receive any signal in the input Channel due to bad conditions on radio wave or other such problems, “ACQUIRING SIGNAL”/ “NO SIGNAL” appears.

Using the remote controller (RC-405)

#FM+

: Selects band.

4 / +¢

: Selects channel.

1 – 6

: Selects preset channel.

26 English