PREPARATION
1MOBILE INSTALLATION
This transceiver allows you to install the front panel and main unit in separate locations. Select safe, convenient locations inside your vehicle that minimize danger to your passengers and yourself while the vehicle is in motion. Consider installing the units at appropriate positions so that knees or legs will not strike them during sudden braking of your vehicle. Try to pick well- ventilated locations that are shielded from direct sunlight.
Note: Unlike the previous KENWOOD mobile transceivers, this transceiver does not allow the front panel and main unit to be joined.
■Main Unit Installation
1 Install the mounting bracket in the vehicle using the 4 supplied
•The bracket must be installed so that the 3 screw holes on the edge of each bracket side are facing the rear.
5 mm x 16 mm
Flat washer
2Position the transceiver, then insert and tighten the 4 supplied hexagon SEMS screws and flat washers.
•Double check that all hardware is tightened to prevent vehicle vibration from loosening the bracket or transceiver.
SEMS screw
•Determine the desired angle of the main unit, using the 3 screw holes on the rear edge of each bracket side.
Position 1:
Position 2:
Position 3:
2
