Kenwood TM-V708A instruction manual Front Panel Installation

■Front Panel Installation

1 Assemble the mounting brackets using the 2 supplied hexagon SEMS screws and flat washers.

• Do not completely tighten the screws in this step.

SEMS screw

2Peel off the paper backing from the rear of the bracket.

3Position the bracket in the vehicle, then install it securely using the 3 supplied self-tapping screws and flat washers.

4 mm x 14 mm self-tapping screw

Flat washer

4Position the grooves on the front panel over the bracket tabs.

1

Bracket tab

5Slide the front panel down until its locking tab clicks.

•The tab on the front panel must be completely locked by the bracket; otherwise vehicle vibration may cause the front panel to fall off the bracket.

Locking tab

6Determine the desired angle of the front panel, then completely tighten the 2 SEMS screws on the bracket.

SEMS screw

3