■Using Program Scan
1 Select the appropriate band.
2 Press [VFO] .
3 Select a frequency within the programmed scan limits, including the frequency limits.
4 Press [VFO] (1 s).
•Scan starts at the frequency currently displayed.
•The 1 MHz decimal blinks while scanning is in progress.
•To reverse the scan direction, turn the Tuning control clockwise (upward scan) or counterclockwise (downward scan). You can also press Mic [UP]/ [DWN].
5To exit Program Scan, press [VFO] again.
Note:
◆If the step size of the current VFO frequency differs from that of the programmed frequencies, VFO scan starts instead of Program Scan.
◆If the step size differs between the lower limit and the upper limit, VFO scan starts instead of Program Scan.
◆If the current VFO frequency is within more than one programmed scan range, the range stored in the smallest channel number is used.
MHz SCAN
MHz Scan monitors a 1 MHz segment of the band, using the current frequency step size. The current 1 MHz digit determines the limits of the scan. For example, if the current frequency is 145.400 MHz, then the scan range would be from 145.000 MHz to 145.995 MHz. The exact upper limit depends on the current frequency step size.
9
1 s
1Select your desired band.
2Press [VFO] to select VFO mode.
3Select a frequency within your desired 1 MHz segment.
4Press [MHz] (Tuning control) (1 s).
•Scan starts at the frequency currently displayed.
•The 1 MHz decimal blinks while scanning is in progress.
•To reverse the scan direction, turn the Tuning control clockwise (upward scan) or counterclockwise (downward scan). You can also press Mic [UP]/ [DWN].
5To exit MHz Scan, press [MHz] again.
51
