PARTIAL OR FULL RESET?
If your transceiver seems to be malfunctioning, initializing the transceiver may resolve the problem. Use Full Reset to initialize all settings that you have customized. Partial (VFO) Reset does not initialize the following settings:
Memory channels | Memory channel names | |
|
| |
Memory channel lockout | Call channels | |
|
| |
Program scan channels | PM channels | |
|
| |
DTMF memory channels | DTMF memory channel | |
names | ||
| ||
|
|
Some of the VFO factory defaults are listed below:
Parameter | Band A | Band B |
|
|
|
VFO frequency | 144.000 MHz | 440.000 MHz |
|
|
|
Frequency step | 5 kHz | 25 kHz |
|
|
|
Tone frequency | 88.5 Hz | 88.5 Hz |
|
|
|
1Press [MNU] to enter Menu mode.
2Press [c]/ [d] to select “AUX
3Press [c]/ [d] to select “RESET
7
4Press [c]/ [d] to select Partial (VFO) Reset, PM Reset {page 43}, or Full Reset, then press [OK].
•A confirmation message appears.
•Press [ESC] to quit resetting.
5Press [OK].
After switching the power OFF, you may press [VFO]+ POWER ON for Partial Reset, or [MR]+ POWER ON for Full Reset. This allows you to skip steps 1 to 4.
You can also use the RESET button to perform Full Reset. See page 12.
Note: When in
39