SELECTING SCAN RESUME METHOD
The transceiver stops scanning at a frequency (or memory channel) on which a signal is detected. It then continues scanning according to which resume mode you select. You can choose one of the following modes. The default is
•Time-Operated mode
The transceiver remains on a busy frequency (or memory channel) for approximately 5 seconds, then continues to scan even if the signal is still present.
•Carrier-Operated mode
The transceiver remains on a busy frequency (or memory channel) until the signal drops out. There is a 2 second delay between signal
•Seek mode
The transceiver remains on a busy frequency (or memory channel) even after the signal drops out and does not automatically resume scanning.
Note: To temporarily stop scanning and monitor weak signals, press the Mic PF key assigned the Monitor function {page 60}. Press the PF key again to resume scanning.
1Press [MNU] to enter Menu mode.
2Press [c]/ [d] to select “AUX
3Press [c]/ [d] to select “SCAN RESUME
4Press [c]/ [d] to select
9 |
5Press [OK] to complete the setting.
6Press [MNU] to exit Menu mode.
47