Kenwood TS-570D instruction manual Microphone, Getting Acquainted

PF

HF TRANSCEIVER TS-570D

ATT	PRE-AMP
VOX	PROC
SEND	AT TUNE
		CH1	CH2	CH3	MIC	LSB
PHONES		1	2	3
						USB
		ANT	REC	FINE	PWR	CW
		4	5	6		FSK
MIC		NB	AGC/TONE REV		KEY
						FM
		7	8	9
						AM
			F.LOCK		DELAY MENU 1MHz

CLR 0 ENT

@6DSP SLOPE (HIGH) control

In SSB or AM mode, turn to change the high cut-off frequency of the receive pass band. Use the control to improve readability of the desired signal when higher frequency interference is present {page 37}.

@7DSP SLOPE (LOW) control

In SSB or AM mode, turn to change the low cut-off frequency of the receive pass band. Use the control to improve readability of the desired signal when lower frequency interference is present {page 37}.

@8RIT/XIT control

After switching ON the RIT or XIT function, turn to select the desired frequency offset {pages 30, 32}.

@9AF control

Turn to adjust the audio frequency gain {page 13}.

#0RF control

Turn to adjust the radio frequency gain {page 13}.

#1IF SHIFT control

Turn to slide the receive pass band either lower or higher in frequency when interference is present {page￿36}.

#2SQL control

Used for muting (“squelching”) the speaker output when no receive signal is present {page 14}.

#3MULTI/CH control

In VFO mode, turn to step the operating frequency up or down {page 29}. In memory channel mode, turn to select a memory channel {page 40}. Also used for selecting Menu numbers when accessing the Menu mode {page 16}, and as a selector to choose settings for various functions activated by front panel buttons.

3 GETTING ACQUAINTED

@8

						DSP SLOPE
					N.R.	HIGH	LOW
					B.C.	T
						U			@6
						L
						C
						W
				CW TUNE		O
									@7
				FILTER
				RIT/XIT		AF	RF
	UP					4	6
DOWN		MR
									@9
			M.IN	–	+	2		8
						0	10		#0
SPLIT	TF-SET	A/B	RIT	CH	IF SHIFT		SQL
						4	6
M/V	A=B	CLEAR	XIT						#1
						2		8
SCAN	M>VFO		M.IN						#2
						0	10

#3

MICROPHONE

qUP/DWN buttons

Use these buttons to step up or down the VFO frequency, memory channels, or Menu selections. Press and hold down to continuously change the settings.

wPTT (Push-to-Talk) switch

The transceiver is placed in transmit mode when this non-locking switch is held down. Releasing the switch returns the transceiver to receive mode.

q

DWN UP

w

PTT

9