10 MEMORY FEATURES
■Memory Channel Lockout
You can lock out Conventional memory channels that you prefer not to monitor during Memory Scan. Memory Scan is described in the next chapter.
1 Press [M/V] to enter Memory Recall mode.
2 Turn the MULTI/CH control, or press Mic [UP] or [DWN] to select a memory channel.
3 Press [CLR].
•Release [CLR] immediately. Pressing it for more than approximately 2 seconds erases the contents of the memory channel.
•A dot appears beside the
•Repeatedly pressing [CLR] adds and removes the channel from the scan list.
QUICK MEMORY
Quick memory is designed for quickly and temporarily saving data without specifying a particular memory channel. Use Quick memory to store data that you will not need during future operating sessions. For example, as you tune across the band looking for DX, it is convenient to store stations that you want to contact. You can quickly jump between several different memory channels as you monitor them.
This transceiver provides five Quick memory channels that can store the following data:
RX frequency | TX frequency |
|
|
Mode for RX | Mode for TX |
|
|
RIT/XIT offset | Microphone gain |
|
|
Transmit power | Keying speed |
|
|
VOX delay time | |
|
|
Receive filter bandwidth1 | VOX ON/OFF |
Speech Processor ON/OFF | Noise Blanker ON/OFF |
|
|
Subtone ON/OFF | CTCSS ON/OFF |
|
|
1 MHz Step ON/OFF | Fine Tuning ON/OFF |
RIT ON/OFF | XIT ON/OFF |
1DSP SLOPE control settings are not stored.
STORING INTO QUICK MEMORY
Each time you store a new frequency, all previously stored frequencies are bumped to their next respective Quick memory channel. When all five memory channels contain frequencies, storing one more frequency bumps the contents of memory channel 5 off the stack (data lost).
24.911 | ➤ 14.235 | ➤ 18.111 | ➤ 7.082 | ➤ | 3.545 |
Memory 1 | Memory 2 | Memory 3 | Memory 4 |
| Memory 5 |
|
| ➜ |
|
|
|
21.200 | ➤ 24.911 | ➤ 14.235 | ➤ 18.111 | ➤ | 7.082 |
Memory 1 | Memory 2 | Memory 3 | Memory 4 | Memory 5 | |
|
| ➜ |
|
|
|
10.103 | ➤ 21.200 ➤ 24.911 ➤ 14.235 ➤ 18.111 | ||||
Memory 1 Memory 2 | Memory 3 | Memory 4 | Memory 5 | ||
You can store data in Quick memory only when using VFO frequencies for both transmitting and receiving.
1Select the frequency, mode, etc.
2Press QUICK MEMO [M.IN].
•Each time [M.IN] is pressed, the current VFO data is written to Quick memory.
Note: When RIT or XIT is ON, this ON status and the offset also will be stored.
44
