15 CONNECTING PERIPHERAL EQUIPMENT
RTTY EQUIPMENT
Use the ACC 2 connector to connect to the RTTY equipment. Connect the RTTY key output line to pin 2 of the ACC 2 connector. Connect the demodulation input line of the RTTY equipment to pin 3 of the ACC 2 connector.
Note: Do not share a single power supply between the transceiver and the RTTY equipment. Keep as wide a separation as possible between the transceiver and the RTTY equipment as practical to reduce
MCP
power supply
MCP | ACC 2 | |
|
Personal computer/ dumb terminal
LINEAR AMPLIFIER
Connect an external transmit power amplifier to the REMOTE connector. Before using the external amplifier, switch ON the linear amplifier control relay via Menu No. 39.
The TX/RX relay response time is 10 ms when you have selected CW Full
Note: The TX/RX control method differs depending on external amplifier models. Some amplifiers enter the TX mode when the control terminal is grounded. For those amplifiers, connect pin 2 of the REMOTE connector to the GND terminal of the amplifier and connect pin 4 of the connector to the control terminal of the amplifier.
|
|
| REMOTE connector |
|
| Pin | Function |
| Linear | No. | |
|
| ||
amplifier | 1 | Speaker output | |
| |||
| AC LINE | 2 | Common terminal |
RF OUTPUT | 3 | Standby; when grounded, the | |
| transceiver enters TX mode. | ||
|
|
| |
Control relay | 4 | When connected with the common | |
R |
|
| terminal, the amplifier enters TX mode. |
T | 2 | 5 | When connected with the common |
4 | 5 | ||
1 | 3 | ||
6 | 7 |
| terminal, the amplifier enters RX mode. |
GND |
| 6 | ALC input from amplifier |
REMOTE Connector | 7 | Approx. +12 V DC is output when in | |
(Rear panel view) |
| TX mode (10 mA max.). | |
ANTENNA TUNER
Use the ANT 1 connector and the AT connector to connect an external antenna tuner. If you connect the external tuner to the ANT 2 connector, the external tuner will not function.
Note: While using an external antenna tuner with the
External antenna tuner
61
