Kenwood TS-570D Beep Function, Display Dimmer, Program Function Button, Operator Conveniences

12 OPERATOR CONVENIENCES

BEEP FUNCTION

Consult the following table to select a function. Selecting OFF assigns no function to the button.

The purpose of the Beep function is to provide an audible signal that conveys information. There are three types of signals:

•To confirm that a button has been pressed.

•To report an error condition; Morse codes are used for some errors.

•To confirm that the selection was completed by pressing [MIC], [PWR], [KEY], [DELAY], or [FILTER] again.

When selecting an operating mode, a Morse code abbreviation for that mode is heard.

Mode	Morse Code Output
LSB	· – · ·		(L)
USB	· · –		(U)
CW	– · – ·		(C)
CW –R	– · – ·	· – ·	(CR)
FSK	· – ·		(R)
FSK –R	· – ·	· – ·	(RR)
AM	· –		(A)

Function	Function
Number
00 to 40	Selects Menu
	No. 00 to 40.
	See “MENU
	CONFIGURATION”.
50	Monitor
51	Voice 1
52	Voice 2
53	DSP Filter
	Monitor

60QUICK MEMO [MR]

61QUICK MEMO [M.IN]

62[SPLIT]

63[TF-SET]

64[A/B]

65[M/V]

66[A=B]

Function Function Number

67[SCAN]

68[M>VFO]

69[M.IN]

70[CW TUNE]

71[CH 1]

72[CH 2]

73[CH 3]

74[FINE]

75[F. LOCK]

76[CLR]

Selects Menu No. 48 to 51.

80 to 83 Ex: 82 selects Menu No. 50.

99 OFF

FM · · – · (F)

You can change the volume of the beep output via Menu No. 01.

1Press [MENU].

2Press [A/B] to select Menu A or Menu B.

3Turn the MULTI/CH control to select Menu No. 41, 42, 43, 44, or 45.

DISPLAY DIMMER

The Display illumination can be switched between 5 levels via Menu No. 00.

PROGRAM FUNCTION BUTTON

The transceiver allows you to customize the function of the front panel [PF] button. When using the optional MC-47 microphone, you can also customize the functions of the Mic [PF1], [PF2], [PF3], and [PF4] buttons. You can assign the following types of functions to these buttons via Menu No. 41 to 45:

•Directly select Menu No. 00 to 40, 48 to 51. No need to press [MENU] and turn the MULTI/CH control.

•Activate a function that is supported by no other front panel buttons.

•Activate the same function as one of the front panel buttons.

4Press [UP], [DOWN], Mic [UP], or Mic [DWN] to select a function number.

• Consult the above table to select a function.

5Press [MENU] to exit Menu mode. The default values are as follows:

• Front panel [PF]: Voice 1

•	Mic [PF1]: [A/B]	•	Mic [PF2]: [SPLIT]
•	Mic [PF3]: [M/V]	•	Mic [PF4]: Monitor

Note:

◆Full Reset returns the functions of the PF buttons to default settings.

◆Function No. 84 accessible in step 4 is not currently available. Pressing the PF button with Function No. 84 assigned will simply cause the transceiver to display a string of error codes.

49