Skew monitor | Skew monitor defines the options required to enable/disable the |
| document skew monitor, set the amount of acceptable document |
| skew, and what action is to be taken when document skew is |
| detected. |
| NOTE: In order for the skew monitor to operate correctly, the |
| following conditions must be true: |
| — The amount of skew must be less than 30 degrees. |
| — The document(s) must be |
| — The document(s) fed must be at least 3 inches / 75 mm |
| wide. |
| ∙ Select Skew Monitor from the Mode Configuration window. |
Mode Number: 01 Mode Name: MODE01 Item #: 8.0
|
| Mode Configuration |
|
| |
Single | Index Format | Patch Reader | Off | ||
6006 | IA Field Width | COIN2 Port Select | n/a | ||
3111 | Level Rules | OCR | n/a | ||
Supprs | IA Display Format | Bar Code Reader | Off | ||
FthenR | Adjoining IA | Printr Controller | Supprs | ||
None | Batching | Front Printer | Off | ||
Off | Length Monitor | Rear Printer | Off | ||
Off | Skew Monitor | Mode Name | MODE0 | ||
NA NA | Footswitch | Overrides | No Sav | ||
|
|
|
| ||
|
|
|
|
|
|
Save & End Session | Don't Save & End Session | ||||
Save & Prev Menu | Don't Save & Prev Menu | ||||
|
|
|
|
|
|
|
|
|
|
|
|
Skew Monitor
On/Off
Detection Range
Error Response
Previous Menu
The following pages provide instructions on how to define the document skew monitor options. When the skew monitor definitions are complete, you will automatically be returned to this
window.
To close the Skew Monitor menu:
∙Select Previous Menu. Proceed to make any additional mode configuration definitions.
