∙ Use the arrow keys to increase or decrease the current distance:
— The left arrow key will decrease the value in 0.125 inch or 1 mm increments.
— The right arrow key will increase the value in 0.125 inch or 1 mm increments.
| — The down arrow key will decrease the value in 1.250 inch or |
| 20 mm increments. |
| — The up arrow key will increase the value in 1.250 inch or 20 mm |
| increments. |
| ∙ Press Enter. |
Rear printer | NOTE: The rear printer is an accessory which must be installed and |
| enabled by your Field Engineer. |
Rear printer defines the options required when using the rear printer accessory.
∙Select Rear Printer from the Mode Configuration window.
Mode Number: 01 Mode Name: MODE01 Item #: 16.0 |
|
|
|
|
|
| |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Mode Configuration |
|
|
|
|
|
| Rear Printer |
|
| |
Single | Index Format | Patch Reader | Off |
| On/Off | ||||||||
| Print Definition | ||||||||||||
6006 | IA Field Width | COIN2 Port Select | n/a |
| |||||||||
| Vertical Start Print Position | ||||||||||||
3111 | Level Rules | OCR | n/a |
| |||||||||
|
|
|
|
|
| ||||||||
Supprs | IA Display Format | Bar Code Reader | Off |
| Previous Menu | ||||||||
FthenR | Adjoining IA | Printr Controller | Supprs |
| |||||||||
|
|
|
|
|
| ||||||||
None | Batching | Front Printer | Off |
|
|
|
|
|
| ||||
|
|
|
|
|
| ||||||||
Off | Length Monitor | Rear Printer | Off |
|
|
|
|
|
| ||||
Off | Skew Monitor | Mode Name | MODE0 |
|
|
|
|
|
| ||||
NA NA | Footswitch | Overrides | No Sav |
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Save & End Session | Don't Save & End Session |
|
|
|
|
|
| ||||||
Save & Prev Menu | Don't Save & Prev Menu |
|
|
|
|
|
| ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
The following pages provide instructions on how to define the rear printer options. When the rear printer definitions are complete, you will automatically be returned to this window.
To close the Rear Printer menu:
∙Select Previous Menu. Proceed to make any additional mode configuration definitions.
NOTE: If the rear printer was not defined as Present during
Accessory Configuration, the following message will appear:
The accessory that you requested is not enabled in
Accessory Configuration.
∙Press Enter to clear the message.
∙Exit from Mode Configuration; refer to the section entitled, Exiting Mode Configuration.
Contact your Field Engineer to install and enable this accessory.