Lanier GX3000 manual Non-compatible Paper

Paper

zOnly one-sided printing is possible.

zRemove sheets from the output tray individually, as they come out.

zBefore handling, make sure printed sheets have fully dried.

zIf you want to stack prints soon after they are printed, we recommend inserting a moisture-absorbent sheet, like copy paper, between prints.

zInk takes time to dry. To prevent sheets from sticking together, remove them from the output tray individ- ually, as they come out.

zIf printing comes out streaked, adjust the paper feed level..

zUse at 15-25°C (59-77°F) and 30-70% humidity.

zUse as soon as possible after opening the package.

zWhen using these sheets, see the instructions supplied with them.

Envelopes

zUp to 20 envelopes can be loaded in tray 1.

zIf the envelopes bulge, flatten them.

zLoad envelopes carefully, because the printable area depends on the orientation.

zSet the lever to the rear position before printing.

Thick paper

zUse tray 1 to load paper lighter than 157 g/m2 (297.6 lb.).

zYou can insert paper with weights up to 255 g/m2 (485.0 lb.) into the bypass tray.

zInsert paper with the print side face up into the bypass tray.

Cautions to Observe After Printing

Depending on the paper type, the ink may take a while to dry. Before handling, make sure printed sheets have fully dried. otherwise, the ink may smudge.

zThe ink may smear depending on the type of image. If this happens, set the envelope selector to the rear position .

Non-compatible Paper

Check if the paper is compatible.

Do not use paper that is:

zwrinkled, folded, or damaged

zwavy at the ends

zcurled

zabsorbent

zdry and conducive to static buildup

zalready printed on (such as the back of preprinted paper)

zpreprinted (unless specified)

zheat sensitive/non-carbon

ztoo thick or thin

zpre-stitched

zglued or tacked

30