5: Commands and Levels

 

 

line <line>

Enters the line level.

lpd <line>

Enters the configure lpd level.

name <text>

Sets the name for this line.

no clear line counters

Restores the serial counters to the aggregate values.

no command mode

Disables command mode for the current line.

no command mode serial string

Prevents the user-defined serial boot string from being

 

used to enter

no command mode signon message

Clears the signon message displayed at boot time and

 

when entering

no name

Removes the name of this line.

parity even

Uses a parity bit on the line for even parity.

parity none

Does not use a parity bit on the line.

parity odd

Uses a parity bit on the line for odd parity.

protocol lpd

Applies Line Printer Daemon (LPD) protocol on the line.

protocol lpd or tunnel

Applies LPD or tunnel protocol on the line.

protocol modbus ascii

Applies Modbus ASCII protocol on the line.

protocol modbus rtu

Applies Modbus RTU protocol on the line.

protocol none

Uses no protocol on the line.

protocol tunnel

Applies tunnel protocol on the line.

reassert

Asserts line status with current configured values.

show

Displays the current status.

show command mode

Shows the command mode settings for the current line.

show history

Displays the last 20 commands entered during the current

 

CLI session.

show line

Displays the current configuration.

show statistics

Shows the line statistics.

state disable

Disables the line so data cannot be sent/received.

state enable

Enables the line so data can be sent/received.

stop bits 1

Uses one stop bit after data on the line.

stop bits 2

Uses two stop bits after data on the line.

terminal <line>

Enters the configure-terminal level.

terminal network

Enters the configure-terminal level for the network.

termination disable

Refrains from terminating the line.

termination enable

Enables 120 ohm line termination in RS485 half-duplex

 

mode.

tunnel <line>

Enters the tunnel level.

write

Stores the current configuration in permanent memory.

xoff char <control>

Sets the xoff character for use with software flow control

 

on this line.

xon char <control>

Sets the xon character for use with software flow control

 

on this line.

line 2 (line:2) level commands

 

auto show statistics

Continuously displays line statistics.

baud rate <bits per second>

Sets the line speed.

clear line counters

Sets the serial counters to zero.

clrscrn

Clears the screen.

command mode always

Sets the current line to always be in command mode.

IntelliBox-I/O 2100 Command Reference

70

Page 70
Image 70
Lantronix 2100 manual Line line, Line 2 line2 level commands