5: Commands and Levels
IntelliBox-I/O 2100 Command Reference 72
protocol lpd or tunnel
Applies LPD or tunnel protocol on the line.
protocol modbus ascii
Applies Modbus ASCII protocol on the line.
protocol modbus rtu
Applies Modbus RTU protocol on the line.
protocol none
Uses no protocol on the line.
protocol tunnel
Applies tunnel protocol on the line.
reassert
Asserts line status with current configured values.
show
Displays the current status.
show command mode
Shows the command mode settings for the current line.
show history
Displays the last 20 commands entered during the current
CLI session.
show line
Displays the current configuration.
show statistics
Shows the line statistics.
state disable
Disables the line so data cannot be sent/received.
state enable
Enables the line so data can be sent/received.
stop bits 1
Uses one stop bit after data on the line.
stop bits 2
Uses two stop bits after data on the line.
terminal <line>
Enters the configure-terminal level.
terminal network
Enters the configure-terminal level for the network.
termination disable
Refrains from terminating the line.
termination enable Enables 120 ohm line termination in RS485 half-duplex
mode.
tunnel <line>
Enters the tunnel level.
write
Stores the current configuration in permanent memory.
xoff char <control> Sets the xoff character for use with software flow control
on this line.
xon char <control>
Sets the xon character for use with software flow control
on this line.
link (config-ethernet:eth0) level commands
clrscrn
Clears the screen.
default duplex
Restores the default duplex setting, which is auto.
default speed
Restores the default speed setting, which is auto-
negotiate.
duplex auto
Sets duplex mode to auto.
duplex full
Sets duplex mode to full.
duplex half
Sets duplex mode to half.
exit
Exit back to interface configuration level
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the current
CLI session.
speed 10
Sets the speed of the Ethernet link to 10 Mbps.
speed 100
Sets the speed of the Ethernet link to 100 Mbps.
speed auto
Sets the speed of the Ethernet link to auto-negotiate.
write
Stores the current configuration in permanent memory.
lpd (lpd) level commands
auto show <line>
Continuously displays lpd status for the specified line.
clrscrn
Clears the screen.
exit
Exits to the enable level.