
6.To install the
Figure 13. Installing the hard-disk-drive EMI shield
Replacing the
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter 2 “Safety information” on page 3.
This section provides instructions on how to replace the
Note: The
To replace the
1.Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2.Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay it down so that the screen is against the surface and the cover is facing up.
3.Remove the computer stand. See “Removing and installing the computer stand” on page 71.
4.Remove the computer cover. See “Removing the computer cover” on page 75.