![](/images/new-backgrounds/1123758/123758167x1.webp)
10.Connect the
11.Position the bracket with the new hard disk drive in the chassis so that the screw hole in the bracket aligns with the corresponding hole in the chassis. Then, install the screw to secure the bracket with the hard disk drive to the chassis.
12.Install the
What to do next:
•To work with another piece of hardware, go to the appropriate section.
•To complete the installation or replacement, go to “Completing the parts replacement” on page 108.
Replacing the
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter 2 “Safety information” on page 3.
This section provides instructions on how to replace the
Note: The
To replace the
1.Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2.Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay it down so that the screen is against the surface and the cover is facing up.
3.Remove the computer stand. See “Removing and installing the computer stand” on page 71.
4.Remove the computer cover. See “Removing the computer cover” on page 75.
5.Remove the