Table 2. Numeric error codes (continued)

Symptom or error

FRU or action, in sequence

 

 

0187

System board.

EAIA data access error—The access to

 

 

EEPROM is failed.

 

 

 

 

0188

System board.

Invalid RFID Serialization Information Area.

 

 

 

 

0189

System board.

Invalid RFID configuration information

 

 

area—The EEPROM checksum is not correct.

 

 

 

 

 

0190

1.

Charge the battery pack.

Critical low-battery error

2.

Battery pack.

 

 

 

0191

1.

Run BIOS Setup Utility, and then save

System Security—Invalid Remote Change

 

current setting by pressing F10.

requested.

2.

System board.

 

 

0192

System board.

System Security— Embedded Security

 

 

hardware tamper detected.

 

 

 

 

 

0199

1.

Run BIOS Setup Utility, and then save

System Security— Security password retry

 

the current setting by pressing F10.

count exceeded.

2.

System board.

 

 

 

01C8

1.

Remove either a Mini-PCI Card or a

Two or more modem devices are found.

 

modem daughter card. Otherwise, press

Remove all but one of them. Press <Esc> to

 

Esc to ignore the warning message.

continue.

2.

System board.

 

 

 

01C9

1.

Remove the Ethernet device that you

More than one Ethernet devices are found.

 

installed; or press Esc to ignore the

Remove one of them. Press <Esc> to

 

warning message.

continue.

2.

System board.

 

 

 

01CA

1.

Remove the wireless LAN device that

More than one Wireless LAN devices are

 

you installed.

found. Remove one of them.

2.

System board.

 

 

 

0200

1.

Reseat the hard disk drive.

Hard disk error—The hard disk is not

2.

Load Setup Defaults in BIOS Setup

working.

 

Utility.

 

3.

Hard disk drive.

 

4.

System board.

 

 

021x

Run interactive tests of the keyboard and

Keyboard error.

the auxiliary input device.

 

 

0220

Load Setup Defaults in BIOS Setup Utility.

Monitor type error—Monitor type does not

 

 

match the one specified in CMOS.

 

 

 

 

0230

System board.

Shadow RAM error—Shadow RAM fails at

 

 

offset nnnn.

 

 

 

 

 

0231

1.

DIMM.

System RAM error—System RAM fails at

2.

System board.

offset nnnn.

 

 

 

 

 

0232

1.

DIMM.

Extended RAM error— Extended RAM fails

2.

System board.

at offset nnnn.

 

 

 

 

 

Related service information

63

Page 71
Image 71
Lenovo W500 System board, Charge the battery pack, Run Bios Setup Utility, and then save, Installed or press Esc to ignore