57 Configuration change, some held jobs were not restored
Something has changed in the printer to invalidate the held jobs. Po ssible changes include:
The printer firmware has been updated.
Paper input options needed for the print job were remov ed.
The print job was created using data from a device in the USB port and the device i s no longer in the USB port.
The printer hard disk contains print jobs that were stored while i nstalled in a different printer model.
Touch Continue to clear the message.
58 Too many bins attached
1Turn the printer off.
2Unplug the power cord from the wall outlet.
3Remove the additional bins.
4Connect the power cord to a properly grounded electrical outlet.
5Turn the printer back on.
58 Too many disks installed
1Turn the printer off.
2Unplug the power cord from the wall outlet.
3Remove the excess disks.
4Connect the power cord to a properly grounded electrical outlet.
5Turn the printer back on.
58 Too many flash options installed
1Turn the printer off.
2Unplug the power cord from the wall outlet.
3Remove the excess flash memory.
4Connect the power cord to a properly grounded outlet.
5Turn the printer back on.
58 Too many trays attached
1Turn the printer off.
2Unplug the power cord from the wall outlet.
3Remove the additional trays.
Troubleshooting 274