Lincoln Electric IM10018-A manual Stacking Hole Stacking Pins, Safety Precautions

A-2 INSTALLATION A-2

SAFETY PRECAUTIONS

Read entire Installation Section before installing the IDEALARC® DC-600 VRD.

ELECTRIC SHOCK CAN KILL.

WARNING

• Only qualified personnel should install this machine.

•Turn the input power OFF at the disconnect switch or fuse box before working on the equipment.

•Do not touch electrically hot parts.

•Always connect the IDEALARC® DC-600 VRD grounding terminal to a good electrical earth ground.

•Set the IDEALARC® DC-600 VRD Power ON/OFF PUSH bUTTON to the OFF position when con- necting power cord to input power.

__________________

SELECT PROPER LOCATION

Place the welder where clean cooling air can freely circulate in through the front louvers and out through the rear louvers. Dirt, dust or any foreign material that can be drawn into the welder should be kept at a mini- mum. Failure to observe these precautions can result in excessive operating temperatures and nuisance shut-downs.

LIMIT ON STACKING

WARNING

•Lift only with equipment of ade- quate lifting capacity.

•be sure machine is stable when lifting.

•Do not lift this machine using lift bail if it is equipped with a heavy

	accessory such as trailer or gas
	cylinder.
FALLING	• Do not lift machine if lift bail is
EQUIPMENT can	damaged.
cause injury.	• Do not operate machine while
	suspended from lift bail.

•Do not stack more than three high.

•Do not stack the IDEALARC® DC-600 VRD on top of any other machine.

------------------------------------------------------------------------

STACKING

Three IDEALARC® DC-600 VRD machines can be stacked.

DO NOT stack more than three machines in one grouping.

DO NOT stack the IDEALARC® DC-600 VRD on another type of machine.

Follow these guidelines when stacking:

1.Select a firm, level surface capable of supporting the total weight of up to three machines (1570 pounds/712 kilograms).

2.Set the bottom machine in place.

3.Stack the second machine on top of it by aligning the two holes in the base rails of the second machine with the two pins on top front of the bot- tom machine.

4.Repeat process for third machine.

NOTE: The machines must be stacked with the Case Front of each machine flush with each other. See Figure A.1.

FIGURE A.1 - Stacking IDEALARC® DC-600 VRD machines

STACKING HOLE

STACKING PINS

TILTING

The IDEALARC® DC-600 VRD must be placed on a stable, level surface so it will not topple over.

IDEALARC® DC-600 VRD