Battery Charging
WARNING
GASES FROM BATTERY can explode.
• Keep sparks, flame and cigarettes away.
BATTERY ACID can burn eyes and skin.
• Wear gloves and eye protection and be 
careful when boosting, charging or working near battery.
To prevent EXPLOSION when:
a)Installing a new battery - disconnect the negative cable from the old battery first and connect the negative cable to the new battery last.
b)Connecting a battery charger - remove the battery from the welder by disconnecting the negative cable first, then the positive cable and battery clamp. When reinstalling, connect the negative cable last.
c)Using a booster - connect the positive lead to
the battery first, then connect the negative lead to the ground lead on the base.
To prevent ELECTRICAL DAMAGE when:
a)Installing a new battery.
b)Using a booster.
Use correct polarity - Negative Ground.
To prevent BATTERY DISCHARGE, if you have an ignition switch, turn it off when engine is not running.
• To prevent BATTERY BUCKLING, tighten nuts on
battery clamp until snug.
1.When replacing, jumping or otherwise connecting the battery to the battery cables, the proper polarity must be observed. Failure to observe the proper polarity could result in damage to the charging circuit. The positive
(+) battery cable has a red terminal cover.
2.If the battery requires charging from an external charger, disconnect the negative battery cable first and then the positive battery cable before attaching the charger leads. Failure to do so can result to damage to the internal charger components. When
HARDWARE
Both English / Metric fasteners are used in this welder.
Engine Maintenance Parts
| ONAN P218 | KOHLER CH20S |
|
|
|
Oil Filter | ONAN | KOHLER 1205001 |
| FRAM PH3614 | FRAM PH3614* |
|
|
|
Air Filter | ONAN | KOHLER 4708303 |
Element | FRAM CA140PL | FRAM CA79 |
|
|
|
Air Filter | ONAN | KOHLER 2408302 |
|
| |
|
|
|
Fuel Filter | ONAN | KOHLER 2505002 |
| FRAM G1 | FRAM G1 |
|
|
|
Spark Plugs | ONAN | CHAMPION RC12YC |
(Resistor | CHAMPION RS14YC | (.030” GAP) |
Type) | (.025” GAP) |
|
|
|
|
*Oil capacity increases from 2.0 Qts. to 2.1 Qts. when using this filter.
