Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
INSTALLATION
TECHNICAL SPECIFICATIONS (Cont’d) - PRO-CUT 80
GAS REQUIREMENTS
Required Gas Flow Rate | Required Gas Inlet Pressure |
70 PSI @ 480 SCHF | 80 to 150 PSI |
(4.8 Bar. @ 13550 LHR) | (5.4 Bar. to 10.2 Bar.) |
RECOMMENDED INPUT WIRE AND FUSE SIZES
For all plasma cutting applications based on U.S. National Electrical Code
Ambient Temperature 30°C or Less
AC Input Voltage | Fuse (Super Lag) |
| Type 75°C |
at | Circuit Breaker | Copper Wire in Conduit AWG | |
60 Hertz | (Delay Type) |
| (IEC) Sizes |
|
|
|
|
230VAC Single Phase | 100 Amps | #4 (21.1mm2) | #4 (21.1mm2) |
460VAC Single Phase | 60 Amps | #8 (8.4mm2) | #8 (8.4mm2) |
230VAC Three Phase | 60 Amps | #8 (8.4mm2) | #8 (8.4mm2) |
460VAC Three Phase | 40 Amps | #10 (5.3mm2) | #10 (5.3mm2) |
| PHYSICAL | DIMENSIONS |
|
Height | Width | Depth | Weight with |
|
|
| Torch Cable |
16.5 Inches | 13.75 Inches | 29.5 Inches | 98 lbs. (44.5 kg.) |
419 mm | 349 mm | 749 mm | (25 ft. cable) |
|
|
| 113 lbs. (51.4 kg.) |
|
|
| (50 ft. cable) |
|
|
|
|