MAINTENANCE
Return to Section TOC
Return to Section TOC
WARNING
ELECTRIC SHOCK can kill.
• Have an electrician install and service this equipment.
•Turn the input power off at the fuse box before working on equipment.
•Do not touch electrically hot parts.
•Prior to performing preventative maintenance, per- form the following capacitor discharge procedure to avoid electric shock.
INPUT FILTER CAPACITOR
DISCHARGE PROCEDURE
1.Turn off input power or disconnect input power lines.
2.Remove the 5/16 in. hex head screws from the side and top of the machine and remove
3.Be careful not to make contact with the capacitor terminals that are located on the top and bottom of the Power Board on the right side of the machine.
4.Obtain a high resistance and high wattage resistor
5.Locate the two capacitor terminals (large hex head cap screws) at the bottom of the Power Board shown in Figure D.1.
6.Use electrically insulated gloves and insulated pli- ers. Hold the body of the resistor and connect resistor leads across the two capacitor terminals. Hold the resistor in place for 10 seconds. DO NOT TOUCH CAPACITOR TERMINALS WITH YOUR BARE HANDS.
7.Repeat the discharge procedure for the other capacitor.
8.Check voltage across the terminals of all capaci- tors with a DC voltmeter. Polarity of capacitor ter- minals is marked on the Power Board above termi- nals. Voltage should be zero. If any voltage remains, repeat this capacitor discharge proce- dure.
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
FIGURE D.1 — LOCATION OF INPUT FILTER CAPACITOR TERMINALS
POWER
BOARD
CAPACITOR
TERMINALS
POWER
RESISTOR
RIGHT SIDE OF MACHINE | INSULATED |
| PLIERS |
INSULATED
GLOVES
