Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
TROUBLESHOOTING AND REPAIR | |||||
|
|
|
| ||
|
|
| |||
Observe Safety Guidelines detailed in the beginning of this manual. |
|
| |||
|
|
|
|
|
|
| PROBLEMS |
| POSSIBLE AREAS OF | RECOMMENDED |
|
| (SYMPTOMS) |
| MISADJUSTMENT(S) | COURSE OF ACTION |
|
|
|
|
|
|
|
|
|
| OUTPUT PROBLEMS |
|
|
No AC welding output. DC welding | 1. | Make sure the Polarity Switch is | 1. Check the operation of the | ||
output and auxiliary power is nor- |
| in the proper position and is | Polarity Switch (S2). Also check | ||
mal. |
|
| “seated” correctly. | the associated wires for loose or | |
|
| 2. | Make sure the electrode is cor- | faulty connections. See Wiring | |
|
| Diagram. |
| ||
|
|
| rect for the process being used. |
| |
|
|
| 2. Check for continuity from lead | ||
|
| 3. Make sure the welding cables are | |||
|
|
| not coiled or too long. | “S2” to lead “E” located in the | |
|
|
| main stator. See Wiring Dia - | ||
|
|
|
| ||
|
|
|
| gram. |
|
|
|
|
| ||
No constant voltage (CV) welding | 1. | Make sure the Range Switch | 1. Check the operation of the | ||
output. Constant current (CC) and |
| (S1) is in the proper position (CV) | Range Switch (S1) and check | ||
the auxiliary power are operating |
| and “seated” correctly. | the associated wires for loose or | ||
normally. |
| 2. Make sure the wire feeder is con- | faulty connections. See Wiring | ||
|
| Diagram. |
| ||
|
|
| nected correctly. |
| |
|
|
|
|
| |
|
|
|
| 2. Check for continuity from lead | |
|
|
|
| C1 to lead W1 located in the | |
|
|
|
| main stator. See Wiring Dia- | |
|
|
|
| gram. |
|
|
|
|
|
|
|
CAUTION
If for any reason you do not understand the test procedures or are unable to perform the tests/repairs safely, contact the Lincoln Electric Service Department for technical troubleshooting assistance before you proceed. Call
